Mixer Nozzle for Polyester Resin 300ml

Mixer Nozzle for Polyester Resin

Designed to be used with the Permagard Styrene Free Polyester Resin, this patented mixer nozzle ensures the two components of the Polyester Resin are fully mixed before they reach the end of the nozzle. The nozzle has a depth gauge embossed into the side of the shaft. This allows the user to easily identify how deep the nozzle is in the masonry. The mixer nozzle can be extended with an extension tube to facilitate deeper injection in larger holes.

As polyester resin sets after 5-10 minutes, these mixer nozzles can be really handy onsite when the original supplied nozzle sets and becomes unusable. Simply unscrew and replace with the additional mixer nozzle and continue the project without wasting the remaining resin.

How to use Polyester Resin

For the 300ml cartridge, unscrew the cap and cut the metal clip off before screwing the mixer nozzle on. Fit the cartridge into the applicator gun and gradually apply pressure to the trigger until the material emerges from the end of the nozzle. You should always waste the first 10ml or so of resin until you get an even colour.

Insert the nozzle into the hole and gun the material out, removing the nozzle slowly as the hole fills up. Once sufficient resin is in the hole, release the pressure from the gun and place the stud to be fixed into the hole with a twisting action to ensure full contact between hole, resin and stud. Allow the resin to cure fully before loading.

Please see label on cartridge for full installation instructions.